Brinly P20-500 BH Push Spreader User Manual

1008066 Rev. BOwner's ManualPush SpreaderMODEL:P20-500BH• Assembly• Installation• Operation• Repair PartsThis manual contains information for the

1008066 Rev. B10READ BEFORE USINGBecome Familiar With The Operation Of The Spreader Before You Put Material In The Hopper.Practice walking with the sp

1008066 Rev. B111015202530NOTE: When determining required setting, the edge of the wingnut is the marker, and not the center of wingnut. When the fl ow

1008066 Rev. B12Media lbs/1000 square feetFlow Control Setting at 3MPHAll AmericanAll Purpose Fertilizer 10-10-10.10 16.0BayerSeason Long Grub Control

1008066 Rev. B13APPLICATION RATE CHARTMedia lbs/1000 square feetFlow Control Setting at 3MPHLawn Insect Killer Granules 1.2 11.5Max Insect Killer for

1008066 Rev. B14Media lbs/1000 square feetFlow Control Setting at 3MPHTurf Builder Lawn Fertilizer New Concentrated Nuggets 34-4-42.7 13.5Starter Fert

1008066 Rev. B15Media lbs/1000 square feetFlow Control Setting at 3MPHGardens Kentucky Bluegrass Grass Seed4 16.0Gardens Kentucky Bluegrass Grass Seed

1008066 Rev. BThe limited warranty set forth below is given by Brinly-Hardy Company with respect to new merchandise purchased and used in the United S

1008066 Rev. B2INTRODUCTIONSAFETYCONGRATULATIONS on the purchase of your new Brinly-Hardy Broadcast Spreader! Your Broadcast Spreader is designed, eng

1008066 Rev. B3SAFETYOPERATE SAFELYKeep bystanders away when you operate this machine.Use this machine for intended purpose only.This machine is inten

1008066 Rev. B4Item Description Part # Qty1 Handle spacer 1007081 12 Carriage bolt, M6 x 25 1007082 13 Washer, M6 1007083 14 Gauge and lever assembly

1008066 Rev. B52215232426448123872413512252146482411313045313233242432141718303941403643473544363738383750503435202851272942201633112020111561093222Ho

1008066 Rev. B6ASSEMBLYTOOLS REQUIRED:2- 10mm Wrenches1. Remove two M6 locknuts and M6 x 45mm long bolts to remove pivot and bracket assembly from wh

1008066 Rev. B7ASSEMBLY3. Insert arm assembly between frame tubes. Re-install pivot and bracket assembly through wheel frame tubes and arm assembly w

1008066 Rev. B810152025301015202530ASSEMBLY5. Push the fl ow control handle downward to the fully closed position, close the shut off plate under the

1008066 Rev. B9Figure 7Figure 8 Avoid damage! Only use a wrench on the lower nut. Do not use wrench on the upper nut.7. Once adjustment is complete,